電利得dreder機車雙B

Locomotive power or battery power indicator number
Green light: sufficient power
Blue light: power is weaker
Red light: low power
No light: abnormal power will shut down automatically 

Notice:
●Before installation, please read the instructions carefully. If the installation is wrong and damage the device, the consumer should be responsible for the loss.
● It is recommended to use with the original charging cable to ensure safe and stable charging.
● Wiring method: Please connect positive power to the positive pole of the product, and connect the black negative pole to the body ground or connect the negative pole of the battery.
● Do not connect the positive cable to other equipment in the locomotive, such as speakers or lights.
●Do not disassemble or modify this product on your own to avoid damage.
● If any abnormality occurs, please contact us or the dealer immediately , and maintain it as it is to detect the warranty.
●Please remove all charging products to ensure safety when getting off.
● This product is fully waterproof without capping, but it is recommended not to soak in water for a long time, so as to avoid abnormalities caused by unknown impurities in water.
 

Scooter panel installation:
1.Use the alcohol swab attached to clean where you want to install.
2. Apply 3M adhesive and press for 30 seconds.
3. Please connect the positive wire of the product to the positive power of the lock. Connect the black negative wire to the negative pole of the battery. Test whether the voltage at the connection is the same as the battery.
4. Use the key to turn on the positive lock. If the LOGO light’s on, that shows the power supply of the locomotive is normal.
5. The installation is completed

Motorcycle handle installation
1. Put the adhesive attached on the bottom of the special holder.
2. Use the alcohol swab to clean the installation
3. After affixing and tightening the strap, cut off the excess length
4. Please connect the positive pole of the product to the positive power of the lock, and then connect the black negative pole to the negative pole of the battery; test whether the voltage at the connection is the same as the battery.
5. Use the key to turn on the positive lock. If the LOGO light’s on, that shows the power supply of the locomotive is normal.
6. The installation is completed.

Compartment installation
1.Use the alcohol swab attached to clean where you want to install.
2. Please connect the positive wire of the product to the positive power of the lock. Connect the black negative wire to the negative pole of the battery.
3. Test whether the voltage at the connection is the same as the battery.
4. Use the key to turn on the positive lock. If the LOGO light’s on, that shows the power supply of the locomotive is normal.
5. The installation is completed

The product has been tested before delivery and enjoys one year warranty service.
Suggested selling price NT1080 (install wages not included)